Front Lift Strap
Use the following Hardware:
- 01 Lift strap.
- 04 aluminum tabs.
- 02 bolts.
- 02 flanged nuts.
- 04 zip ties.
Installation Instructions:
1. Loop one side of the strap around the fork (under the triple clamp).
2. Insert one of the bolts to the rectangular aluminum tab.
3. Insert the bolt together with the tab in the hole of the strap (from the outside).
4. Insert the bolt through the second hole (hole in the tip of the strap).
5. Insert the second tab and then secure the nut (loosely).
6. Loop a zip tie around the fork on the upper part of the triple clamp.
7. Once it's all in place, insert a 2nd zip tie from under the strap and loop it to the 1st zip tie (step 6).
8. Adjust both zip ties and then the bolt & nut firmly.
9. Repeat the installation process for the other side.
Installation Video
Note: Take a look at the pictures to help you understand how you should place the bolt, nut and tabs as well as the zip ties correctly.
Rear Lift Strap
Use the following Hardware for all models with tail light except XC/SX models:
- 01 Lift strap.
- 02 Hex Head Screws (40mm).
- 02 Unthreaded Spacers.
Installation Instructions:
1. Insert the hex head screw to the 2nd hole (2nd hole from the tip of the strap).
2. Insert the hex head screw to the 1st hole.
3. Insert the hex head screw to the spacer.
4. Fix the head head screw under the fender.
5. Repeat on the other side.
Note: If you have Acerbis plastics installed on your dirt bike, use the first hole for an adequate fitment (first hole from the tip).
Use the following Hardware for all models without tail light except XC/SX models:
- 01 Lift strap.
- 02 Hex Head Screws (40mm).
- 02 Unthreaded Spacers.
Installation Instructions:
1. Insert the hex head screw to the aluminum spacer.
2. Insert the hex head screw to the 2nd hole (2nd hole from the tip of the strap).
3. Insert the hex head screw to the 1st hole.
4. Fix the head head screw under the fender.
5. Repeat on the other side.
Note: If you have Acerbis plastics installed on your dirt bike, use the first hole for an adequate fitment (first hole from the tip).
Use the following Hardware for XC/SX models:
- 01 Lift strap.
- 02 Hex Head Screws (25mm).
- 02 Unthreaded Spacers.
Installation Instructions:
1. Insert the hex head screw to the spacer.
2. Insert the hex head screw to the 1st hole (1st hole from the tip of the strap).
3. Fix the hex head screw under the fender.
4. Repeat on the other side.
Note: Take a look at the pictures for correct installation.
