Rear Lift Strap
Use the following hardware:
- 01 Rear Lift strap.
- 01 Hex Head Screws.
- 01 Unthreaded Spacer.
- 01 nut.
Installation Instructions:
1. Drill a hole on the rear plastic fender as shown on the picture.
2. Trim your seat so that the head of the bolt can fit adequately.
3. Place the lift strap under the sub-frame on both sides.
4. Pass the bolt into one aluminum spacer, then through both strap holes (use the first hole on both tips) and finally through the drilled hole of the rear plastic fender made.
4. Under the rear plastic fender tighten the nut to the bolt.
Note: Please take a look at the pictures for correct installation.
Rear Lift Strap for 2019 TX & FX models
Use the following Hardware:
- 01 Rear Lift strap.
- 02 Hex Head Screws.
- 02 Unthreaded aluminum spacers.
Installation Instructions:
1. Insert the bolt to the 2nd hole of the strap.
2. Insert the bolt to the aluminum spacer.
3. Tighten the bolt to the dirt bike.
4. Repeat on the other side.
Note: Please take a look at the pictures for correct installation.